Clean Or Replace The Liner - Thermo Scientific TRACE GC Ultra Maintenance And Troubleshooting Manual

Clean or Replace the Liner

OPERATING SEQUENCE
Clean or Replace the Liner
Materials needed
•
•
•
•
•
•
•
•
WARNING! This operation must be carried out at low temperature to avoid burns. Therefore,
before beginning the sequence, the injector must be cooled to room temperature.
PRECAUTIONS
WARNING! When handling organics solvents you must take precautions to avoid health
hazards. Refer to Appendix A,
1. While in stand-by condition, press OVEN to
access the oven control table.
and press OFF.
2. Scroll to
Temp
Maintenance and Troubleshooting Manual
Screwdriver (P/N 205 026 03)
Liner (see Table 9-2, on page 145)
Graphite seal (P/N 290 134 17)
Ultrasonic bath
Methanol/acetone mixture (1:1)
Non metallic sharp tool
Septum (P/N 313 132 25)
Tweezers
Reagents Safety Information
Temp
Initial time
Ramp 1
Chapter 9
Maintaining a PTV Injector
for more information.
.
OVEN
50 50 <
5
10.0
151