Thermo Scientific TRACE GC Ultra Maintenance And Troubleshooting Manual page 382

Chapter 17
Maintaining Detectors in Stack Configuration
2. Disconnect the signal, excitation voltage and
ignition/heating cables from the FPD detector.
3. Disconnect the signal, excitation and heater
cables from the ECD detector.
4. Loosen the nut that fixes the ECD detector to its
base body with the proper tool contained in the
standard outfit and remove the detectors from
the ECD base body.
382
Replace the Silver Seal (FPD on ECD)
Maintenance and Troubleshooting Manual