Thermo Scientific TRACE GC Ultra Maintenance And Troubleshooting Manual page 352

Hide thumbs Also See for TRACE GC Ultra:

Table of Contents

Maintaining Detectors in Stack Configuration

10. Disconnect the signal, excitation and heater

cables from the ECD detector

11. Remove the heat shield.

12. Remove the heater from the top of the ECD

detector unscrewing and removing the 4 mm

Allen fixing screw. Use a 3 mm Allen wrench.

Clean or Replace the Collecting Electrode (FID on ECD)

Maintenance and Troubleshooting Manual

Chapters

Table of Contents