Thermo Scientific TRACE GC Ultra Maintenance And Troubleshooting Manual page 367

Clean or Replace the Collecting Electrode (FPD on ECD)
10. Place the FPD detector on the ECD top cover,
paying attention that the aluminium ring has
been inserted in the correct position, then
tighten the fixing nut.
11. Reconnect the excitation and heater cables to
the ECD detector.
12. Reconnect the signal, excitation voltage and
ignition/heating cables to the FPD.
13. Switch on the GC power supply.
Maintenance and Troubleshooting Manual
Maintaining Detectors in Stack Configuration
Chapter 17
367