Thermo Scientific TRACE GC Ultra Maintenance And Troubleshooting Manual page 322

Chapter 15
Maintaining a Photoionization Detector
7. Insert the lamp holder into the lamp housing
8. Tighten the two knurled screws to fix the lamp
holder to its housing.
9. In the
RIGHT DETECTOR (PID)
scroll subsequently to
and press ON.
Lamp
CAUTION Before starting a new analysis
wait about 30 minutes so the
lamp output can stabilize.
322
control table
,
Mkup Sheath Gas
and
Maintenance and Troubleshooting Manual
Replace the UV Lamp