Replace The Heat Shields - Thermo Scientific TRACE GC Ultra Maintenance And Troubleshooting Manual

Replace the Heat Shields

OPERATING SEQUENCE
Replace the Heat Shields
Materials needed
•
•
•
•
•
•
WARNING! This operation must be carried out at low temperature to avoid burns. Therefore,
before beginning the sequence, the detector must be cooled to room temperature.
PRECAUTIONS
WARNING! When handling organics solvents you must take precautions to avoid health
hazards. Refer to Appendix A,
Maintenance and Troubleshooting Manual
Detector fixing tool (P/N 205 021 50)
FPD maintenance kit (P/N 190 045 89)
1 mm Allen wrench
Screwdriver
Methylene chloride or methanol
Paper towels
Maintaining a Flame Photometric Detector
Reagents Safety Information
Chapter 14
for more information.
301