Multi-Drop, User-Defined - Intermec JANUS 2020 User Manual

JANUS 2020 Hand-Held Computer User's Manual (4MB)

Multi-Drop, User-Defined

Purpose:
Default:
Syntax:
Scan:
12-42
Multi-Drop, User-Defined is an option of User-Defined protocol. You must set
the POL and SEL characters to define a unique device address. For help, see
"POL and SEL Combinations for Multi-Drop Protocol" in Appendix C.
Note: You must select User-Defined protocol before you can enable Multi-Drop,
User-Defined protocol. For help, see "Communications Protocol, Configure" earlier in
this chapter. To activate Multi-Drop, User-Defined protocol, select User-Defined in the
configuration command Communications Protocol, Activate.
Disabled
PMdata
Acceptable values for data are:
0 Disabled
1 Enabled
One of these bar codes:
Disable Multi-Drop, User-Defined
*$+PM0*
*$+PM0*
Enable Multi-Drop, User-Defined
*$+PM1*
*$+PM1*
BC
NF