Table of Contents
Advertisement
2-58
Intercom Hold Button
Programming Steps
1. Press the ICM HOLD BTN flex button (FLASH 07, Button #19). The
2. Enter a valid number (00-28) on the dial pad to correspond to one of
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
The Intercom Hold Button flash rate is the rate at which your Hold button
flashes when you receive an intercom call and your station's intercom
mode selector switch is in the T position. This flash rate can be
programmed to 29 different options identified in the Flash Rate table.
This enables the programmer to customize the key system configuration
to desired flash rates.
By default, Intercom Hold Button flash rate is set for a Red 15 ipm
Flash (09).
System Parameters
Programming Steps
If the system is in the programming mode, continue using the program
codes. If starting to program here, enter the programming mode.
following message displays:
ICM HO LD B TN
R ED 1 5 IP M F LAS H
the 29 available options. (Refer to
display updates.
Press FLASH and dial [09]. The following message displays:
SY ST EM PA R AMET ER S
EN TE R B U TTON N UM BE R
System Parameters
0 0-2 8
Table 2-6: Flash
Rates.)
Advertisement
Table of Contents
