Table of Contents
Advertisement
4-18
Station Identification
Programming Steps
1. Press the STATION ID flexible button (FLASH 50, Page B, Button #1).
2. Enter a valid number on the dial pad to identify type of telephone:
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
Each system port must be programmed to identify the type of station
that operate on that port. Each station type must be identified. By
default, all Key Telephone Boards (DTIB) default to ID 006 (24-Button
Digital Telephone), all Single Line Boards (SLIB) default to ID 6.
STAT ION ID
K EY SET -
SP
24 B TN
[1-5]=DSS Console (Refer to
Map"
for details.)
[6]=SLT without Message Wait
[7]=SLT with Message Wait (90 Vdc)
[006]= 24-Button Telephone
[007]=12-Button Telephone
[008]=8-Button Telephone
[009]=16-Button Telephone
[015]=SLA
[016]=Large Display 30-Button Telephone
display updates.
When identifying a station as a DSS / DLS console, you must also enter
the station number of the key telephone to which the DSS / DLS console
is associated. To associate a DSS console with Station 100, the entry
would be 1100 [HOLD].
0- 8
"Station ID for DSS / DLS Console With
Page B Introduction
Advertisement
Table of Contents
