Programmable Flash Rates
Description
The Message Call Back DSS/BLF flash rate is the rate at which a DSS
button of a station returning your message flashes. This flash rate can be
programmed to 29 different options identified in the flash rate table. This
enables the programmer to customize the key system configuration to
desired flash rates. By default, Message Callback DSS/BLF flash rate is set
for a Red 120 ipm Flutter (11).
Do Not Disturb - DSS / BLF
Programming Steps
1. Press the DND – DSS/BLF flex button (FLASH 07, Button #6). The
2. Enter a valid number (00-28) on the dial pad to correspond to one of
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
The Do Not Disturb DSS/BLF flash rate is the rate at which a DSS button of
a station flashes when you are in a Do Not Disturb mode. This flash rate
can be programmed to 29 different options identified in the flash rate
table. This enables the programmer to customize the key system
configuration to desired flash rates. By default, Do Not Disturb DSS/BLF
flash rate is set for a Red 60 ipm Double Wink (04).
following message displays:
D N D D SS / B LF
R ED 6 0 IP M D B L WIN K
the 29 available options. (Refer to
display updates.
0 0-2 8
Table 2-6: Flash
Rates.)
2-49