Table of Contents
Advertisement
System Features 2 Programming
Station ID Lock
Programming Steps
1. Press the STATION ID LOCK flex button (FLASH 06, Button #8). The
2. Enter a 0 or 1 on the dial pad to enable/disable the use of this feature.
3. Press HOLD to save the entry. A confirmation tone is heard.
Description
The Station ID Lock feature enables the installer/programmer to lock the
station ID of all extensions on the system. It also prevents the loss of
station programming that results when a different station type is
plugged into a port already designated as another station type. This
feature is programmed on a system-wide basis. By default, the Station ID
Lock feature is disabled.
The proper procedure(s) for changing the Station ID with the Station ID
Lock feature enabled:
1. Enter programming mode and disable the Station ID Lock feature.
2. Plug the new device type into the jack. Set is automatically identified.
3. Enter programming mode and disable the Station ID Lock feature.
4. Enter programming and perform Station ID programming (FLASH 50,
following message displays:
STAT ION LOCK
D ISA BLE D
[0] = Disabled
[1] = Enabled
Page B, Button #1). Set is automatically identified.
0- 1
2-39
Advertisement
Table of Contents
