Table of Contents
Advertisement
Page A Introduction
Display Ring Assignments
Programming Steps
1. Press FLASH 40, Page A, Button #13 to display ring assignments.
2. Press FLASH 40, Page A, Button #13 additional times to cycle to the
DID/TIE Signaling
Programming Steps
1. Press FLASH 40, Page A, Button #14. The following message
2. Dial a valid number (0-2) on the dial pad.
3. Press HOLD to save the entry.
Assignments are displayed in sets of 8, up to the number
programmed. The following format displays the assignments.
D D DR R DD D R R D D D R R D D D RR
D D DR R DD D R R D D D R R D D D RR
DDD = Destination
RR:
[0] = No Ring
1 [D] = Day Ring
2 [N] = Night Ring
3 [DN] = Day/Night Ri ng
4 [S] = Special Only
5 [DS] = Day/Special
6 [NS] = Night/Special
7 [A] = All Modes (Day/Night/Spe cial)
next group of eight ring assignments. Ring assignments are displayed
in numerical order, from the lowest to the highest number.
displays:
D ID / TIE SIG N ALIN G
WIN K
[0] = Immediate Start
[1] = Wink Start
[2] = Delay Start
0- 2
3-17
Advertisement
Table of Contents
