Table of Contents
Advertisement
Page B Introduction
T-1 trunking provides services called Automatic Number Identification
(ANI) and Dialed Number Identification Service (DNIS). The T-1 feature
supports both of these services. The
DNIS, or an ANI and DNIS combination on a per channel (line) basis. By
default, the T-1 Signal Type Option is Loop Start.
T-1 Ringback
Programming Steps
1. Press the RINGBACK flexible button (FLASH 40, Page B, Button #2).
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
3. Press the HOLD button. A confirmation tone is heard and the display
Description
The T-1 Ringback option supports T-1 channels which require ringback
tone to be transmitted to the caller while a call is ringing. Some carriers
require the system to generate the ringback tone, this feature allows the
system to provide this option. Ringback tone is not used with the DISA,
TIE Line, or DID signal options. By default, the T-1 Ringback Option is
enabled.
T-1 Dial Tone
Programming Steps
1. Press the DIAL TONE flexible button (FLASH 40, Page B, Button #3).
The following message displays:
T- 1 R IN GB ACK
EN AB LE
[0] = Disabled
[1] = Enabled
updates.
The following message displays:
T- 1 D IAL TON E
D ISA BLE D
Triad
Digital Systems support ANI,
0- 1
0- 1
3-23
Advertisement
Table of Contents
