Table of Contents
Advertisement
3-20
Page B Introduction
Programming Steps
If the system is in the programming mode, continue using the program
codes. If starting to program here, enter the programming mode. If Page
B CO Line features must be changed:
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only
3. Press HOLD to save the entry. A confirmation tone is heard and the
4. Press the PAGE B flexible button (Button #20). The following message
Description
This section describes the procedures and steps necessary to program
CO Line attributes. When entering the CO Line attributes portion of the
database, the programmer may decide to enter information for a range
of CO lines or one specific CO Line.
CO L INE AT TR IB UT ES
SEL ECT A CO LIN E RA N GE
one line is being programmed, enter that number twice (001 001).
If HOLD is pressed without entering a CO range, ALL CO lines
(001-144) are selected.
display updates. Flexible Button #19 (Page A) is lit.
displays:
XXX - XXX PA GE B
EN TE R B U TTON N UM BE R
XXX-XXX = CO Line Range
001-048 =
Triad 1/2
001-144 =
Triad 3
Page B Introduction
Advertisement
Table of Contents
