Page A Introduction
Page A Introduction
Programming Steps
1. Press FLASH and dial [40]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
When entering the CO Line attributes portion of the database, the
programmer may decide to enter information for a range of CO lines or
one specific CO Line.
Range programming lets the programmer change a specific parameter or
a few parameters for an entire range of CO Lines leaving intact the
remaining data fields that do not require change. Those data fields
continue to operate with the previously programmed data. By default,
Page A is shown.
CO L INE AT TR IB UT ES
SEL ECT A CO LIN E RA N GE
one line is being programmed, enter that number twice (001 001).
If HOLD is pressed without entering a CO range, ALL CO lines
(001-144) are selected.
display updates. Flexible button #19 (Page A) is lit. The following
message displays to indicate current programming of that line or
group of lines:
XXX - XXX PA GE A
EN TE R B U TTON N UM BE R
XXX-XXX = CO Line Range
001-048 =
Triad 1/2
001-144 =
Triad 3
3-3