Table of Contents
Advertisement
Enhanced 911 (Proctor PBX-ANI-LINK Unit)
Enhanced 911 (Proctor PBX-ANI-LINK Unit)
Programming Steps
1. Press the ENHANCED 911 button (FLASH 06, Button #14). The
2. Enter a 0 or 1 on the dial pad to enable/disable the use of this feature.
Description
The Enhanced 911 feature enables 911 integration with the Proctor PBX-
ANI-LINK product. Loop Start lines can be connected to the Proctor unit
and programmed to be 911 lines (FLASH 40, PAGE A, Button 15). When a
911 call is made from a station in the system, the system will send
911XXXX (XXXX=Station # that placed the 911 call) in DTMF format to the
Proctor. If the station number is less than 4 digits, a leading 0 will
automatically be added. The Proctor unit then accesses a call trunk and
sends the information in the proper format to the 911 Center.
Conditions
following message displays:
EN H AN CED 9 11
D ISA BLE D
[0] = Disabled
[1] = Enabled
The 911 Feature (FLASH 06, button 13) must also be enabled for the
Proctor Integration to work.
Only the lines connected to the Proctor should have the 911 Enable
programmed (FLASH 40, PAGE A, Button 15).
It is recommended to have a power failure procedure in place to
ensure that 911 calls are always routed. Refer to FLASH 09, Button 7
for programming information.
0- 1
2-43
Advertisement
Table of Contents
