Table of Contents
Advertisement
3-16
CO Direction
Programming Steps
1. Press the TRUNK DIRECTION flexible button. (FLASH 40, Page A,
2. Enter a valid number (0-3) on the dial pad which corresponds to the
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
CO Lines can be programmed on a per CO Line basis for the type of CO
Line desired: Incoming, Outgoing, or Incoming and Outgoing.
Incoming
Outgoing
Incoming and Outgoing
Button #12). The following message displays:
CO D IR EC TION
IN COMIN G - OUT GOIN G
desired CO type:
[0] = Out-of-Service (OOS)
[1] = Incoming Only
[2] = Outgoing Only
[3] = Both Incoming and Outgoing
display updates.
Incoming restricts the CO Line for incoming calls only.
Users can place call on hold, park the call, and other stations can pick
up the call.
Outgoing restricts the CO Line to outgoing calls only.
Users can place call on hold, park the call, and other stations can pick
up the call.
Incoming and outgoing type allow calls to be received or dialed out.
By default, all CO Lines default to both incoming and outgoing type.
Page A Introduction
0- 3
Advertisement
Table of Contents
