Deny Table - Vodavi STARPLUS Triad 1 System Programming Manual

9-12
Rules for Entries that Reference Special Tables
For entries referencing the first three special tables a specific area code
must be identified (one for each table needed). Then make note as to
how the numbers are dialed when dialing numbers to this area code (i.e.,
with a leading digit [1] or no leading digit [1] ).
The entry into the Allow Table would be entered as follows:
For an entry that references the Home Area Code table (Special Table 4)
the entry may also be entered to expect or not expect a leading digit [1].
In fact, in some cases it may be desirable to enter both of the following
entries:

Deny Table

Programming Steps
1. Press the DENY TABLE A or DENY TABLE B flexible button (FLASH 70,
Leading Digit [1]: Enter [BB] [1] [XXX] [DDD] [S] or,
Non-Leading [1]: Enter [BB] [XXX] [DDD] [S]
BB = Bin Number (Bins 17-19)
XXX= Area Code (must match AREA-X entry)
DDD = Do Not Care digit (three entries, DND button)
[S] = Search Special Table Command (TRANS button)
Leading Digit [1] -- Enter [BB] [1] [DDD] {S}
and/or,
Non-Leading [1] -- Enter [BB] [DDD] {S}
BB = Bin number (Bin 20)
DDD = Do Not Care digit (three entries, MUTE button)
{S} = Search Special Table Command (TRANS button)
If both leading digit [1] and non-leading digit [1] entries are made
to reference the same table, it is necessary to place the leading digit
[1] entry ahead of the non-leading digit [1] entry in the Allow Table.
Button #2 or #4). The following message displays:
D EN Y TAB LE
01 E
A
Toll Restriction
02E