Introduction
Initialize Station Attributes
Programming Steps
1. Press the STATION ATTRIBUTES flexible button (FLASH 80,
2. Press the HOLD button. A confirmation tone is heard.
Description
The Station Parameters may be initialized setting all data fields to their
original, default values. The following data fields are returned to their
default value upon initializing the Station Attributes.
Program
Flex
Code
Button
FLASH 50
PAGE A
10
11
12
13
14
Button #3). The following message displays:
IN ITIA LIZ E S TATION S
P RE SS
HO LD
Table 11-3: Station Attribute Defaults
1
Paging Access
2
Do Not Disturb
3
Conference Enable/Disable (Per Station)
4
Executive Override
5
Privacy (Per Station)
6
System Speed Dial Access
7
Line Queuing
8
Preferred Line Answer
9
Off-Hook Voice Over (OHVO)
Call Forwarding
Forced Least Cost Routing (LCR)
ACD Supervisor Monitor w/Barge-In
Executive Override Block
CO Line Ringing
Features
11-11
Default Value
(after initialization)
Enabled
Enabled
Enabled
Disabled
Enabled
Enabled
Enabled
Enabled
Disabled
Enabled
Disabled
Disabled
Disabled
Muted Ring