Table of Contents
Advertisement
3-52
Route 001 is used as the Busy DID Route. DO NOT program any entries in
this Route if you intend to provide a busy tone to callers dialing a busy
DID/DVIS number.
ISDN Programming - Page A
Programming Steps
1. Press FLASH and dial [45]. The following message displays:
2. Enter a valid number for the range of lines being programmed. If only
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
This section describes the procedures and steps necessary to program
CO Line attributes. When entering the CO Line attributes portion of the
database, the programmer may decide to enter information for a range
of CO lines or one specific CO Line. Range programming lets the
programmer change a specific parameter or a few parameters for an
entire range of CO Lines leaving intact the remaining data fields that do
not require change. Those data fields continue to operate with the
previously programmed data. By default, Page A is shown.
ISD N AT TR IB U TES
SEL ECT A SLOT R AN G E
one line is being programmed, enter that number twice (001 001).
If HOLD is pressed without entering a CO range, ALL CO lines (001-048 or
001-144) are selected.
display updates. Flexible button #19 (Page A) is lit. The following
message displays to indicate current programming of that line or
group of lines:
XXX - XXX PA GE A
EN TE R B U TTON N UM BE R
XXX-XXX = CO Line Range
001-048=Triad 1/2
001-144 =
Triad 3
ISDN Programming - Page A
Advertisement
Table of Contents
