3-18
Description
The DID/TIE Signaling feature can be programmed for one-way direct
access inward dialing access to specific stations on specific DID lines
without going through an Attendant answering position.
911 Trunk
Programming Steps
1. Press FLASH 40, Page A, Button #15 to designate the line for 911
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
When the 911 system feature is enabled (FLASH 06), this identifies which
CO lines are to be used for placing 911 calls. The Attendant is alerted via
the display and flexible button as to the time, date, and station number(s)
that placed the 911 call.
Electronic Key Telephone Service
Programming Steps
1. Press FLASH 40, Page A, Button #16 to enable or disable extended
use. The following message displays:
91 1 TR U N K
D ISA BLE D
[0] = Disabled
[1] = Enabled
display updates.
Lines must be programmed for 911 to enable the 911 feature.
Failure to enable lines for 911 disables 911 calls.
key telephone service. The following message displays:
EK TS
D ISA BLE D
Page A Introduction
0- 1
0- 1