Table of Contents
Advertisement
System Timers
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
The Message Wait Reminder Timer determines the time between
repeated reminder tones to a key telephone with a message waiting.
Digital station users may be reminded of a message waiting on their
telephone with an audible signal presented at a timed interval.
By default, the Message Wait Reminder Tone is set at 000 (disabled) and is
variable from 000-104 minutes.
SLT Hook Flash Timer
Programming Steps
1. Press the SLT HOOK FLASH TIMER flex button (FLASH 01,
2. Enter a valid number on the dial pad that corresponds to
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
The SLT Hook Flash Timer determines how long an SLT user presses the
hook switch for it to be considered a valid on hook (disconnect) request.
An on-hook shorter in duration (but longer than the Hook Switch Bounce
Timer) is considered a Hook Flash (transfer) request. Refer to
By default, the SLT Hook Flash Timer is set at 10 (one second) and is
variable from 0.5-2.0 seconds.
display updates.
Button #14). The following message displays:
H OOK SW ITCH TIME
10
0.5-2.0 seconds in 1/10 second increments.
display updates.
Some SLTs have a fixed or programmable Flash Timer (Flash or Tap
button). This Hook Switch Timer must be set longer than the SLT Flash
Timer to allow Hook Flash transfer.
0 5-2 0
2-13
Figure 2-1
.
Advertisement
Table of Contents
