Table of Contents
Advertisement
Page A Introduction
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
3. Press HOLD to save the entry. A confirmation tone is heard and the
4. Reset the KSU
Description
Extended key telephone service (EKTS) is used with the ISDN BRI to
simulate DID calling.
Conditions
[0] = Disabled
[1] = Enabled
display updates.
-or-
Reset only the card using "config" without resetting the whole
telephone switch. To do this, type config at the Enter Password
prompt. Then type r<space>k (k = slot number). For example,
r<space>2 indicates that the BRI card is in slot 2.
Shared numbers are routed using the standard DID tables (Flash 43
and 44).
Numbers that are not shared will only ring on the designated
channel. If the designated channel is busy, the caller will receive a
busy signal.
To support EKTS, telephone switch software must be 3.0G or higher
and BRIB firmware must be 0.1G or higher.
When ordering EKTS, request basic EKTS, not cache EKTS.
Order only one SPID and one primary directory number per channel.
Secondary directory numbers (e.g., DID numbers) are shared across
each channel to a maximum of 32 channels.
Sharing can only be done between circuits on one card.
3-19
Advertisement
Table of Contents
