Table of Contents
Advertisement
Programmable Flash Rates
Description
The Line Queue Button flash rate is the rate at which the Line Queue
button flashes after queueing onto a busy line. This button flashes when
the busy line becomes available. This flash rate can be programmed to
29 different options identified in the flash rate table which enables the
programmer to customize the key system configuration to desired flash
rates. By default, Line Queue Button flash rate is set for a Red 480 ipm
Flutter (08).
Do Not Disturb Button
Programming Steps
1. Press the DND BTN flex button (FLASH 07, Button #18). The
2. Enter a valid number (00-28) on the dial pad to correspond to one of
3. Press HOLD to save the entry. A confirmation tone is heard and the
Description
The Do Not Disturb Button flash rate is the rate at which your Do Not
Disturb button flashes when you place your station in a Do Not Disturb
mode. This flash rate can be programmed to 29 different options
identified in the flash rate table. This enables the programmer to
customize the key system configuration to desired flash rates. By default,
Do Not Disturb Button flash rate is set for Red Steady On (01).
following message displays:
D N D B TN
R ED S TEA DY ON
the 29 available options. (Refer to
display updates.
0 0-2 8
Table 2-6: Flash
Rates.)
2-57
Advertisement
Table of Contents
