Before Using the
Machine
1
Original and Paper
2
Copying
3
Sending and
Receiving
4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only)
6
Remote UI (imageCLASS
MF7480/MF7470 Only)
7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
8.
Press [RX Start] if you require a faxed copy of the
information.
If you do not require a faxed copy of the information, press [End].
Checking Dialing Line
■
Checking dialing line function enables you to configure the setting
on whether to check for a dial tone.
1.
Press
(Additional Functions).
2.
Press [Communications Settings] → [TX
Settings] under <Fax Settings> → [Check Dial
Tone Before Sending].
The Check Dial Tone Before Sending screen appears.
3.
Select [On] or [Off], then press [OK].
The Check Dial Tone Before Sending mode is enabled only after you
restart the machine (the main power switch is turned off, then back
on again).
4.
Press [Done] repeatedly until the Send Basic
Features screen appears.
Dialing an Overseas Number (With Pauses)
■
When you dial or register an overseas number, you may need to
insert a pause within the number.
1.
Press
(SEND).
2.
Place your originals.
Back
Previous
3.
Enter the international fax number, then press
[Pause].
Example:
–
International Dialing Code: 010
–
Country code: 1
–
Area code: 516
–
Fax number: XXX-XXXX
[Pause]: Enter the pause time equivalent in length to the time
required for the dial tone to be heard after dialing is completed.
[Backspace]: Press when a wrong number is entered. The number
immediately to the left of the cursor is deleted, enabling you to enter
the correct number.
–
The pause time differs in length, depending on whether it is
entered in the middle or end of a fax number.
–
The pause time entered in the middle of a fax number (lower-
case p) can be changed to any number between 1 and 15
seconds. (See "Pause Time, " on p. 11-14.)
–
The pause time entered at the end of a fax number (upper-case
P) is set to 10 seconds long. (This length cannot be changed.)
–
Two or more pauses can be entered consecutively.
–
The location of a pause and the actual pause time may differ
depending on the telephone system. Contact your local
authorized Canon dealer or your local telephone company for
further details.
4.
Press [OK].
TOP
Next
4-43