Before Using the
Machine
1
Original and Paper
2
Copying
3
Sending and
Receiving
4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only)
6
Remote UI (imageCLASS
MF7480/MF7470 Only)
7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
–
If the top edge of the original is not aligned with the back edge of the
platen glass (by the arrow in the top left corner), your original may not be
scanned correctly, depending on the scan mode that you have set.
–
Originals of the following sizes can be placed either vertically or
horizontally. However, the scanning speed for horizontally placed
originals is somewhat slower than vertically placed ones. Place originals
horizontally when scanning with a Preset Zoom, such as when enlarging
an LTR original onto 11" x 17" paper.
–
Platen glass: LTR, STMT
–
Feeder: LTR
–
Horizontally placed LTR and STMT originals are referred to as LTRR and
STMTR.
–
11" x 17" and LGL originals must be placed horizontally on the feeder.
Back
Previous
On the Platen Glass
■
The machine automatically detects the size of the following originals: 11" x
17", LGL, LTR, and LTRR.
1.
Lift the feeder.
This machine is equipped with an open/close sensor (A) on the
feeder (see circled area in the above illustration). When placing
originals on the platen glass, lift the feeder high enough so that the
sensor does not touch the feeder. If the sensor continues to touch
the feeder, the size of the originals may not be detected correctly.
TOP
Next
2-6