Canon imageCLASS MF7460 Reference Manual page 239

Before Using the
Machine 1
Original and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
HTTP Settings
You can restrict the use of Remote UI.
1.
Press (Additional Functions).
2.
Press [System Settings] → [Network Settings] →
[TCP/IP Settings] → [▼] → [▼] → [Use HTTP].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using
keys), then press (Log In/Out) to enter the System Settings menu.
The Use HTTP screen appears.
3.
Select [On] or [Off].
[On]: Uses the Remote UI.
[Off ]: Does not use the Remote UI.
4.
Press [OK].
5.
Press [Done] repeatedly until the Additional
Functions screen closes.
6.
Restart the machine.
Turn off the machine, wait at least 10 seconds, then turn it on.
Port Number Settings
Depending on your network environment, you can change the port
number for each protocol.
1.
Press
2.
Press [System Settings] → [Network Settings] →
[TCP/IP Settings] → [▼] → [▼] → [Port Number
– (numeric Settings].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using
keys), then press
The Port Number Settings screen appears.
3.
Press a desired protocol key, then enter the
number using
4.
Press [OK].
5.
Press [Done] repeatedly until the Additional
Functions screen closes.
6.
Restart the machine.
Turn off the machine, wait at least 10 seconds, then turn it on.
Back Previous Next
(Additional Functions).
(Log In/Out) to enter the System Settings menu.
– (numeric keys).
TOP
– (numeric
6-38