Canon imageCLASS MF7460 Reference Manual page 56

Before Using the
Machine 1
Original and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
– If you are placing the original on the platen glass, the size of the
original is detected after the feeder is closed. Make sure to close
the feeder before scanning.
– Open the feeder and remove the original from the platen glass
when scanning is complete.
– The machine cannot detect the size of STMT and STMTR originals
that are placed on the platen glass. After pressing
follow the instructions on the screen to specify the original size.
You can also manually select the paper size.
Into the Feeder
■
– If the same original is fed through the feeder repeatedly, the
original may fold or become creased, and make feeding
impossible. Limit repeated feeding to a maximum of 30 times
(this number varies, depending on the type and quality of the
original).
– If the feeder rollers are dirty from scanning originals written in
pencil, perform the feeder cleaning procedure. (See "Cleaning the
Machine, " on p. 9-2.)
– Always smooth out any folds in your originals before placing
them into the feeder.
– Set the originals one by one if they are very thin (10 to 16 lb (37
to 52 g/m
(Start),
– 11" x 17" and LGL originals must be placed horizontally in the
feeder.
1.
Adjust the slide guides to fit the size of your
originals.
Back Previous Next
2 )) or very thick (28 to 32 lb bond (105 to 128 g/m
TOP
2 )).
2-8