Before Using the
Machine
1
Original and Paper
2
Copying
3
Sending and
Receiving
4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only)
6
Remote UI (imageCLASS
MF7480/MF7470 Only)
7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
–
Place the originals horizontally in the following cases:
–
If you are enlarging LTR originals to 11" x 17"
–
If you are enlarging STMT originals to 11" x 17"
–
Placing an original horizontally means setting the original with the
longer side sideways.
–
If you are reducing 11" x 17" originals to LTR with Auto Orientation in
Copy Settings (from the Additional Functions screen) set to [Off ], load
LTRR paper into a paper drawer or the stack bypass.
1.
Press
(COPY).
2.
Place your originals.
3.
Press [Copy Ratio].
4.
To reduce the original image, select a preset
reduction ratio. To enlarge the original image,
select a preset enlargement ratio. Following
your selection, press [Done].
5.
Select the paper size.
–
If you set [Auto] for [Paper Select], the machine selects the paper
best suitable to the selected ratio.
–
If you copy highly transparent originals, such as transparencies,
the correct paper size may not be selected.
6.
Press
(Start).
–
To return the copy ratio to 100%, press [Direct].
–
To cancel all settings and return the machine to the Standard
mode, press
(Reset).
Back
Previous
Zoom by Percentage
You can reduce or enlarge images by any copy ratio, in 1%
increments. The available copy ratios are from 50% to 200%. The
same copy ratio is used for the horizontal (X) and vertical (Y) axes.
1.
Press
(COPY).
2.
Place your originals.
3.
Press [Copy Ratio].
4.
Press [-] or [+] to set a copy ratio, then press
[Done].
You can also use
–
(numeric keys) to enter values, and
to clear your entries.
You can change the value by pressing [-] or [+], even if you have
entered the value using
–
(numeric keys).
If you enter a value outside the setting range, a message prompting
you to enter an appropriate value appears on the screen.
5.
Select the paper size.
–
If you set [Auto] for [Paper Select], the machine selects the paper
best suitable to the selected ratio.
–
If you copy highly transparent originals, such as transparencies,
the correct paper size may not be selected.
TOP
Next
(Clear)
3-11