Canon imageCLASS MF7460 Reference Manual page 365

Before Using the
Machine 1
Original and Paper
2
Copying
3
Memory fills up immediately when you try to send.
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
Q Is the machine overheated?
A Unplug the machine and let it cool for about 5
minutes. Then plug in the machine and try sending
again.
Q Are you sending at a high resolution?
A If you want to keep your document quality, divide the
document into some parts and send them separately.
A If your document does not contain fine text or
photographs, select a lower resolution.
A If your document contains fine text or photographs,
send it directly rather than using a memory
transmission.
Q Is a document stored in memory, leaving little
memory available?
A Print, send, or delete any documents stored in
memory.
Back
Faxes sent from the machine are spotted or dirty.
Q Is the recipient's machine working properly?
A Check the machine by making a copy. If the copy is
clear, the problem may be in the recipient's machine.
If the copy is spotted or dirty, clean the scanner
components. (See "Scanning Area, " on p. 9-4.)
Q Are the scanning components of the machine
clean?
A If the received document is spotted or dirty, clean the
scanning components. (See "Scanning Area, " on
p. 9-4.)
The documents you sent are too light.
Q Is the density setting set towards [Light] and the
Original Type setting set to [Photo]?
A Change the density setting to [Dark] and the Original
Type setting to [Text], and send the document again.
(See "Scan Density and Original Type Settings, " on
p. 4-16.)
TOP
Previous Next
10-35