Canon imageCLASS MF7460 Reference Manual page 390

Before Using the
Machine 1
Common Settings
Original and Paper
Energy Consumption in Sleep Mode
2
Copying
3
Stack Bypass Standard Settings
Sending and
Receiving 4
Printing and
Scanning
5
Network (imageCLASS
MF7480/MF7470 Only) 6
Remote UI (imageCLASS
MF7480/MF7470 Only) 7
System Settings
8
Paper Feed Method Switch
Maintenance
9
Troubleshooting
10
Appendix
Language Switch
11
Reserved Display (B/W)
Table of Contents
Index
Sets the amount of energy that the machine consumes when it is in the Sleep mode.
– Low
– High
Sets the paper size and type that the stack bypass uses beforehand. This setting is useful if you
always load the same paper size and type into the stack bypass.
If the Stack Bypass Standard Settings are stored when using the Send function, you can also use
the stack bypass to receive I-fax or fax documents.
– On
– Off
– When printing on special types of paper, such as heavyweight paper or transparencies, be sure to
correctly set the paper type, especially if you are using heavyweight paper. If the type of paper is not set
correctly, it could adversely affect the quality of the image. Moreover, the fixing unit may become dirty
and require a service repair, or the paper could jam.
– If you are using the stack bypass as a paper source for Copy and Receive (I-fax or fax), you must select
the stack bypass when specifying the Drawer Eligibility for APS/ADS setting. (See "Automatic Paper
Selection/Automatic Drawer Switching," on p. 2-21.)
Sets whether the printer speed is the priority for your job, or whether to print on a specific side
of the paper. This is useful when you want to make one- or two-sided prints on preprinted paper
(paper which has logos or patterns already printed on it) without changing the orientation of
the paper of the paper loaded in a paper source.
– Stack Bypass (Speed, Print Side)
– Paper Drawer 1 (Speed, Print Side)
– Paper Drawer 2 (Speed, Print Side)
Selects the language on the touch panel display. (See Chapter 13, "Specifications, " in the Basic
Operation Guide.)
Sets whether to reverse the contrast on the touch panel display for better viewing. If you find it
hard to read what is being shown on the touch panel display, try using this mode.
– On
– Off
Back Previous Next
TOP
11-7