ABB IRB 365 Product Manual page 54

3 Installation and commissioning
3.3.4 Orienting, assembling and securing the manipulator
Continued
Moving the upper arms to installation position
Use this procedure to release the brakes and move the upper arms into installation
position.
1
2
3
Continues on next page
54
Action
Supply power to connector R1.MP on the robot,
to be able to use the brake release button:
• 0V on pin 12.
• 24V on pin 11.
DANGER
Incorrect connections, such as supplying power
to the wrong pin, may cause all brakes to be re-
leased simultaneously and instantly!
Note
Do not interchange the 24V and 0V pins.
If they are mixed up, damage can be caused to
internal electrical components.
Release the brakes by pressing the brake release
button and move the upper arms to calibration
position.
Disconnect the 24V supply from the R1.MP con-
nector.
© Copyright 2022 ABB. All rights reserved.
Note
xx2100000785
Releasing the brakes on page 62
xx2200000021
Product manual - IRB 365
3HAC079185-001 Revision: A