ABB IRB 365 Product Manual page 132

5 Repair
5.4.3 Replacing the telescopic shafts and shaft components
Continued
Refitting the telescopic shaft
Use these procedures to refit the rotation axis.
Refitting the telescopic shaft
1
2
3
4
Continues on next page
132
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
Move the conical connection over to the new
telescopic shaft axis 5.
Add Loctite 638 on the conical surfaces and Loc-
tite 243 on the threads
Refit the two telescopic shafts on the motor axis
4 and 5.
Tighten mounting clamping screws.
© Copyright 2022 ABB. All rights reserved.
Note
Tightening torque:
10 Nm
xx2100000751
xx2100000750
Tightening torque:
10 Nm
Product manual - IRB 365
3HAC079185-001 Revision: A