5.2 Error Log - CPI CMP 200 Series Service Manual

3C
Interfacing and Programming
3C.5.1 Setting Time And Date (Cont)
Step Action (membrane console)
8.
NOTE: The time does not increment when in the SET TIME & DATE mode.
9. Press EXIT to return to the UTILITY
menu.
3C.5.2 Error Log
This utility allows display of the error messages stored in the generator's error log. The error log storage limit is 200 messages at which point
the generator will replace the oldest with the most recent.
The ERROR LOG menu for the membrane console is shown below.
ERROR # 1 OF 18
DATE: 8-19-2002
ERROR CODE: 200
ERROR MESSAGE: ANODE HEAT WARN
80
KVp:
EXIT
Use and disclosure is subject to the restrictions on the title page of this CPI document.
Page 3C-14
To synchronize GenWare® to the clock in
your computer, check the Auto box in the
lower left corner of the Date and Time
window.
Doing so will transfer the computers time
and date settings to the time and date
dialog boxes in the upper half of the Date
and Time window. Clicking on Apply will
apply those settings to the generator's
clock.
Press Close to exit the Date and Time
window.
* ERROR LOG *
100
:
mA ms:
CMP 200
Action (PC GenWare®)
TIME: 13:09
+
-
200
®
X-Ray Generator Service Manual
CPI Canada Inc.
Action (Touchscreen GenWare®)
To synchronize GenWare® to the clock in
your touchscreen, press the Synchronize
button in the lower left corner of the Date
& Time Control Window.
Doing so will transfer the Touchscreen
computer's time and date settings to the
time and date dialog boxes in the upper
half of the Date and Time Control
Window. Pressing Apply will apply
those settings to the generator's clock.
Press Close to exit the Date & Time
Control Window.
Ch # 901476-04 Rev. C