CPI CMP 200 Series Service Manual page 68

CPI Canada Inc.
INTERFACING, PROGRAMMING, AND
3.0.0 INTRODUCTION
3.1.0 Purpose
This chapter describes the interfacing of the CMP 200® and CMP 200® DR X-ray generators to Bucky's,
interlocks, collimator lamp, etc, and to the AEC chambers (if the AEC option is fitted).
Generator programming and AEC calibration is also covered in this chapter.
This chapter contains the following sections.
Section
3A
3B
3C
3D
Use and disclosure is subject to the restrictions on the title page of this CPI document.
®
CMP 200 X-Ray Generator Service Manual
CHAPTER 3
CALIBRATION
Not Used
Not Used
Interfacing and Programming
AEC (Automatic Exposure Control) calibration
Ch # 901476-03
Interfacing, Programming, & Calibration
Title
Rev. A
3
Page 3-1