CPI CMP 200 Series Service Manual page 197

3D
AEC Calibration
3D.2.1 AEC Board (Solid State Chambers) Cont
Tables 3D-1 and 3D-2 show the pin outs for both the 6 pin circular connectors and for the 7 pin in-line
connectors on the AEC board in figure 3D-1.
FUNCTION
Anode, right (refer to note below)
Cathode, right (refer to note below)
Anode, middle
Cathode, middle
Anode, left (refer to note below)
Cathode, left (refer to note below)
Ground
FUNCTION
Anode, right (refer to note below)
Cathode, right (refer to note below)
Anode, middle
Cathode, middle
Anode, left (refer to note below)
Cathode, left (refer to note below)
Ground
NOTE:
Jumpers JW1 to JW8 swap the left and right fields from J1 to J4 and J11 to J14 as per the table below.
CHANNEL
1
2
3
4
Use and disclosure is subject to the restrictions on the title page of this CPI document.
Page 3D-4
Table 3D-1: Pin outs for 6 pin circular connector J1 to J4
Table 3D-2: Pin outs for 7 pin in-line connector J11 to J14
LEFT / RIGHT FIELDS AS PER
TABLES 3D-1, 3D-2
Jumper JW1, JW2 pins 1-2 (N)
Jumper JW3, JW4 pins 1-2 (N)
Jumper JW5, JW6 pins 1-2 (N)
Jumper JW7, JW8 pins 1-2 (N)
PIN
3
4
1
6
2
5
Connector shell
PIN
1
2
3
4
5
6
7
LEFT / RIGHT FIELDS SWAPPED RELATIVE
TO TABLES 3D-1, 3D-2
Jumper JW1, JW2 pins 2-3 (R)
Jumper JW3, JW4 pins 2-3 (R)
Jumper JW5, JW6 pins 2-3 (R)
Jumper JW7, JW8 pins 2-3 (R)
®
Rev. A CMP 200
CPI Canada Inc.
Service Manual Ch # 901476-05