Runtime License Agreement (Touchscreen Console) - CPI CMP 200 Series Service Manual

1
Pre-installation
1.6.0

RUNTIME LICENSE AGREEMENT (TOUCHSCREEN CONSOLE)

User / End User License Agreement
You should carefully read the following terms and conditions before using this product. It contains
software ("Software"), the use of which is licensed by Communications & Power Industries Canada Inc.
("CPI") to you, the original end user, for your use only as set forth below. If you do not agree to the terms
and conditions of the agreement, do not use the software. If you use any part of the software, such use
shall indicate that you accept these terms.
1. The Software embedded in this Product is protected by international intellectual property rights and
treaties. You may use the software in object code form only and are prohibited from distributing the
software as such. There is no grant of any of the Software's proprietary source code. This license
does not grant you any rights to patents, copyright, trade secrets, trademarks, or any other rights with
respect to the Software. You are not authorized to modify or to create derivative works based on this
software. You are not authorized to decompile, disassemble or otherwise reverse engineer the
embedded Software. CPI reserves all rights not expressly granted herein.
2. You are authorized to copy the Software only for the following purposes.
a. If such copying is an essential step in the use of the Software and in accordance with this
agreement; or
b. To make an archival copy for back up purposes.
3. If making a copy pursuant to Section 2 above, you must ensure that all trademark, copyright and
intellectual property notices are reproduced and included on any copies that are made.
4. The Software embedded in this Product is provided to you within the same warranty terms, as those
offered for the Products, except for any third party software, which is offered "as is" and without
warranties of any kind including, but not limited to: warranties of merchantability, fitness for a
particular purpose, title and non-infringement.
5. The Software embedded in this Product is not intended for use in or with systems, devices, or
products intended to support of sustain life or for any aviation or nuclear reactor application in which
the software or its failure, malfunction, or inadequacy could directly or indirectly cause or contribute to
personal injury or death or significant property damage. It is your responsibility, as the User or End
User, to ascertain the suitability of the Software for your particular situation and / or application.
6. This agreement is effective until terminated. The agreement shall terminate immediately if you fail to
adhere to the terms and conditions set forth herein. Upon termination, you must immediately cease
all use of the Software and destroy any and all copies of the embedded Software in your possession.
7. This agreement represents the entire agreement between you and CPI with respect to the Software,
and supersedes all other agreements or representations, whether written or oral. The terms of this
agreement can only be modified by the express written consent of both parties. If any part of this
agreement is held to be unenforceable as written, it will be enforced to the maximum extent allowed
by applicable law, and without effect to the enforceability of any other part.
8. Should you have questions regarding the use of the Software, please contact support@cmp.cpii.com.
Use and disclosure is subject to the restrictions on the title page of this CPI document.
Page 1-28
®
CMP 200 X-Ray Generator Service Manual
CPI Canada Inc.
Ch # 901476-01 Rev. C