CPI CMP 200 Series Service Manual page 17

1
Pre-installation
1.2.3 Safety Warning Labels (Cont)
HT Tank - Transformer Terminals Notice
This notice is printed on the HT tank lid and cautions against over-tightening the nuts on the transformer
feedthrough terminals (for the primary of the HT transformers).
Danger High Tension Notice
This notice is printed on the HT tank lid. High voltage may be present at the primary terminals on the tank
lid board, at the output high voltage connectors, and at the mA/mAs measuring jacks if the shorting link is
opened for mA/mAs measurements.
Auxiliary Transformer Labels
These labels are fixed on the outer face of the auxiliary transformer and indicate the presence of high
voltage taps on the primary of 120, 200, 240, 400 and 480 VAC. Ensure the main power disconnect is
switched off and appropriate documentation is consulted before attempting to service this component.
HIGH VOLTAGE HAZARD: Be certain that you are aware of all potential high voltage
locations and hazards as detailed in this section before removing any covers, or attempting
any service on this X-ray generator.
Use and disclosure is subject to the restrictions on the title page of this CPI document.
Page 1-14
®
CMP 200 X-Ray Generator Service Manual
CPI Canada Inc.
Ch # 901476-01 Rev. C