2.4 Aec Interconnect; 2.5 Dr Imaging System; 3.0 Generator Programming; 3.1 Entering Into Programming Mode - CPI CMP 200 Series Service Manual

CPI Canada Inc.
3C.2.4 AEC Interconnect
Refer to chapter 3D for an overview of AEC theory, for AEC chamber connections, and for the AEC calibration
procedure.
3C.2.5 DR imaging system
CMP 200® DR X-ray generators are factory-configured to interface with one or more DR imaging systems.
Refer to the compatibility statement in chapter 1 to determine which DR imaging system(s) this model of
generator is compatible with. The DR imaging system is connected to 37-pin "D" connector J25 on the
generator control board. The corresponding digital imaging supplement will be included in the front of this
manual. Refer to that supplement for the installation and setup procedure of the DR imaging system.
3C.3.0 GENERATOR PROGRAMMING
If you are using a membrane console, the generator may be programmed and calibrated via the control
console or via PC GenWare®. When using the console for programming and calibration, all programming /
calibration menus are displayed on the LCD display window on the console. The "soft key" buttons on the
console are used to navigate through the programming screens and to select and enter values in this section.
When using the touchscreen console, the generator must be programmed and calibrated via
Touchscreen GenWare®. This requires the GenWare® utility software, which can be accessed via the
GenWare® button in the System Utilities menu. Alternately, PC GenWare® may be used to program the
generator if desired.
3C.3.1 Entering Into Programming Mode
To enter into the programming mode if using the membrane console, follow the steps below.
Use and disclosure is subject to the restrictions on the title page of this CPI document.
®
CMP 200 X-Ray Generator Service Manual
1
2
3
4
BACK
Figure 3C-2: Programming / calibration mode reference
MENU
Ch # 901476-04 Rev. C
Interfacing and Programming
5
6
7
8
FORWARD
IND100R_006A.CDR
3C
Page 3C-7