Safety Warning Labels - CPI CMP 200 Series Service Manual

1
Pre-installation
1.2.2 Safety Notices and Warnings (Cont)
NOTE:
1.2.3

Safety Warning Labels

This subsection defines the safety labels used inside and outside the generator cabinet.
NOTE:
WARNING:
WARNING:
This information is provided to help you establish safe operating conditions for both you and your X-ray
generator. Do not operate this X-ray generator except in accordance with these instructions, and any
additional information provided by the X-ray generator manufacturer and / or competent safety
authorities.
Weight Label
This label is attached to the main generator cabinet and to the HT tank, and states the approximate
weight of the main cabinet with the HT tank, and the weight of the HT tank separately. Do not attempt to
lift these items without proper assistance.
Use and disclosure is subject to the restrictions on the title page of this CPI document.
Page 1-12
THE SET SCREW COLLAR MUST BE POSITIONED ON THE UPPER HALF OF THE
TILT ARM TO PREVENT PERSONAL INJURY SHOULD THE TOUCHSCREEN SLIP
WHILE ADJUSTING THE VIEWING HEIGHT.
USE THE PROVIDED ALLEN KEY TO ENSURE THAT THE SET SCREW COLLAR IS
LOCKED INTO POSITION SUCH THAT THERE IS NO LESS THAN 25 mm (1 INCH)
OF CLEARANCE BETWEEN THE BOTTOM EDGE OF THE TOUCHSCREEN
CONSOLE AND THE TOUCHSCREEN BASE PLATE WHEN THE TOUCHSCREEN IS
ADJUSTED TO ITS MINIMUM HEIGHT.
PLEASE BE SURE TO SUPPORT THE TOUCHSCREEN CONSOLE WHEN
ADJUSTING ITS VIEWING POSITION.
THESE LABELS AND WARNINGS ARE PROVIDED TO ALERT SERVICE
PERSONNEL THAT SERIOUS INJURY WILL RESULT IF THE HAZARD IDENTIFIED
IS IGNORED.
SWITCH OFF THE MAIN POWER DISCONNECT AND ALLOW SUFFICIENT TIME
FOR ALL CAPACITORS TO DISCHARGE BEFORE REMOVING ANY COVERS.
IF ANY COVERS MUST BE REMOVED FOR SERVICE, TAKE ALL REQUIRED
PRECAUTIONS WITH RESPECT TO THE HAZARD(S) AND IMMEDIATELY
REPLACE THE COVERS WHEN THE NEED FOR REMOVAL IS COMPLETED.
®
CMP 200 X-Ray Generator Service Manual
CPI Canada Inc.
Ch # 901476-01 Rev. C