CPI CMP 200 Series Service Manual page 136

CPI Canada Inc.
3C.7.7 Tube Calibration (Cont)
Use these steps to perform the tube auto calibration.
Step Action (membrane console)
1.
From the GENERATOR SETUP menu
select GEN CONFIGURATION.
2. Select TUBE CALIBRATION.
Select FOCAL SPOT. Toggle the button
3.
to select the desired focal spot to
calibrate (SMALL or LARGE).
Start with SMALL.
Press and hold the X-RAY button (or use
4.
the optional hand switch) to begin the
calibration procedure.
When finished calibrating the small focus,
5.
press RETURN and then repeat
calibration on the large focal spot.
When auto-calibration is completed, press
6.
EXIT to return to the GENERATOR
SETUP menu.
Press EXIT SETUP to exit out of the
7.
setup and calibration mode and return to
the normal operation mode.
NOTE: SHOULD AN ERROR OCCUR DURING AUTO CALIBRATION, AN ERROR MESSAGE WILL BE DISPLAYED. THE GENERATOR
WILL THEN LIMIT THE TUBES OPERATION TO THE RANGE IN WHICH IT WAS CALIBRATED, THUS ALLOWING FOR
PARTIAL OPERATION OF THE GENERATOR.
Use and disclosure is subject to the restrictions on the title page of this CPI document.
®
CMP 200 X-Ray Generator Service Manual
Action (PC GenWare®)
Select Auto Tube Calibration from the
Setup menu, or use the auto calibration
button on the GenWare® toolbar.
Under Focus, select the desired focal
spot to calibrate (small or large).
Start with small.
Press and hold the X-RAY button (or use
the optional hand switch) to begin the
calibration procedure.
Repeat the calibration on the large focal
spot.
Ch # 901476-04 Rev. C
Interfacing and Programming
Action (Touchscreen GenWare®)
Press the button on the GenWare
toolbar to access the Tube Calibration
utility.
Under Focus, select the desired focal
spot to calibrate (small or large).
Start with small.
Press and hold the X-RAY button (or use
the optional hand switch) to begin the
calibration procedure.
Repeat the calibration on the large focal
spot.
Page 3C-67
3C