CPI CMP 200 Series Service Manual page 195

3D
AEC Calibration
3D.1.0 INTRODUCTION
This chapter describes interfacing and setup / calibration of the various AEC board assemblies that are used
in CMP200® and CMP200® DR X-ray generators.
THIS X-RAY GENERATOR IS FACTORY CONFIGURED TO BE COMPATIBLE WITH SPECIFIC AEC
DEVICE(S). REFER TO THE COMPATIBILITY STATEMENT AT THE FRONT OF THIS MANUAL FOR
THE FACTORY CONFIGURED AEC COMPATIBILITY OF THIS GENERATOR.
A SET OF AEC COMPATIBILITY MATRIXES IS LOCATED AT THE FRONT OF THIS MANUAL. EACH
AEC BOARD HAS A CORRESPONDING AEC COMPATIBILITY MATRIX, I.E. FOR AEC BOARD 734614-
XX, USE AEC COMPATIBILITY MATRIX SUP73461400.
THE AEC COMPATIBILITY MATRIXES LIST THE AEC CHAMBERS / PREAMPLIFIERS THAT
EACH VERSION OF AEC BOARD IS COMPATIBLE WITH, AND THEY ALSO SHOW THE I/O PIN
CONNECTIONS AND THEIR FUNCTIONS, AS WELL AS RELATED NOTES.
This chapter contains background information that is relevant to AEC operation. This is located at the back
of this chapter, and should be understood before beginning AEC calibration.
3D.2.0 WIRING THE AEC PICKUP DEVICE TO THE GENERATOR
1. Note the part number that is printed on the AEC board in the generator.
2. Connect the AEC device to the AEC board as per 3D.2.1 to 3D.2.4. Supplementary information is in
the AEC compatibility matrixes.
Use and disclosure is subject to the restrictions on the title page of this CPI document.
Page 3D-2
®
Rev. A CMP 200
CPI Canada Inc.
Service Manual Ch # 901476-05