Table of Contents
Advertisement
Shocks
20. Pressurize the shock body cylinder with nitrogen gas to
specification.
21. Install the small button-head screws back into each valve
assembly.
22. Reinstall the eyelet hardware and test shock. After being
compressed, the piston rod must fully extend from the
body.
Walker Evans Air Shock Disassembly
IMPORTANT: Verify the protective outer boot is not
torn or damaged. If damaged, inspect the shock shaft
for damage. Replace shock shaft if damage is found.
1
4
1.
Place the body cap (1) of the shock in the vise so that the
shock rod (2) is facing downward.
2.
Remove the service port screw (3) and release the pressure
with the shock charging needle. Verify all pressure is
released.
3.
Place the body cap (1) in the vise, so that the shock rod (2)
9.20
4.
5.
6.
7.
8.
3
Walker Evans Air Shock Assembly
1.
6
5
2.
9
8
7
Do not over-torque the shock rod bearing cap or shock
2
3.
4.
IMPORTANT: Never re-insert the fill tool needle back
into the shock to check pressure after initial charging.
The amount of gas required to fill the tool will give a
false pressure reading.
Always completely discharge the shock and refill to
obtain an accurate pressure reading.
5.
6.
is facing upward.
Slowly loosen the shock rod bearing cap (4) and remove
from the shock.
Empty all the shock oil from the shock body and discard
the old oil.
Inspect the valve stack (5) as needed. Replace any worn,
wavy, bent valve shims.
If valve shim service or adjustment is done, torque the
piston retaining bolt (6) to 25-30 ft-lb (34-41 N-m).
Piston Retaining Bolt: 25-30 ft-lb (34-41 Nm)
If required, replace the bearing cap seal (7) and o-ring (8).
Place the specified amount of fluid into the shock body.
CAUTION
Do not overfill the shock oil level. Too much shock oil
may cause the shock rod to hydro lock.
Insert and torque down the bearing cap (4) assembly into
the shock body (9).
Bearing Cap Torque: 85 ft-lb (115 N-m)
CAUTION
performance will be compromised.
Flip shock over in the vise so that the shock rod is facing
downward.
Pressurize the shock to specification. Hold the fill tool
needle in the port for thirty seconds to allow the nitrogen
gas to stabilize.
Check for any leaks.
Reinstall the protective boot and carefully reinstall shock.
= T
= T
Advertisement
Chapters
Table of Contents
