Moving The Sj5000 - Agilent Technologies U1840A Medalist sj5000 Hardware Manual

3
Installation

Moving the sj5000

N O T E
3-4
The lifting device used to move the sj5000 must be rated to lift and carry a
2 tonne load. The forks of the lifting device should be a minimum of 1.0 m
in length with a minimum fork spacing of 0.5 m (the inside gap between
the forks).
When handling the sj5000, bear in mind the following:
• The machine is designed for transportation and handling by
either a hydraulic pallet truck or forklift.
• The machine is designed to be lifted from any of its four
sides, however, when inserting the forks of the lifting device
under the machine, care must be taken to ensure that the
lower panels are not damaged as a result of poor handling.
• When lowering the machine from an elevated position the
lifting device operator must ensure that all sides of the
machine are clear from obstructions.
Ensure that the correct space is available on the production line
(see the Site Preparation Manual) before lifting and moving the
sj5000 into position.
It is important that the machine is aligned so that its fixed
conveyor rail is in-line with the fixed rails of the input and
output conveyors.
1
Disconnect the power cord.
2
Secure the X and Y axis with shipping clamps.
3
Use a hand truck to lift the machine approximately one inch.
4
Remove the packaged parts from under the machine.
5
Turn the four adjustable feet so that they go approximately
two inches into the machine.
6
Carefully move the machine to the desired location.
7
Slowly lower the machine so that the feet are about one inch
from the floor.
8
Turn the four adjustable feet out they touch the floor, and
then adjust the height until the system conveyor height
matches that of the input and output conveyors.
9
Once the correct height has been reached, tighten the feet
locking nuts with the 46 mm spanner.
10
Ensure that all four feet are solidly on the ground.
11
Lower and remove the hand truck.
Agilent U1840A Medalist sj5000 Hardware Manual