Agilent Technologies U1840A Medalist sj5000 Hardware Manual page 72

6
Auto Width Adjust Conveyor Setup
Conveyor Width Adjustment
6-10
If calibration is successful, proceed with the following:
• Check using calipers that the distance between the conveyor
rails is the same as the value in the Current Width field.
• The conveyor width can now be adjusted:
• Enter the width required into the Required Width field
and press Enter.
Click Move to move the conveyor rail in or out to the
•
required width. Every time the AWA is accessed the
conveyor will automatically home itself for the first move,
and then move to the required width entered.
If the width entered is below or above the minimum and
maximum widths respectively, the conveyor will move to
either the minimum or maximum width depending on the
value.
• To stop the conveyor when moving to a specified width, click
Stop to cancel the move operation.
If any problems occur when the conveyor is attempting to move,
an error message will be displayed.
Agilent U1840A Medalist sj5000 Hardware Manual