Agilent Technologies U1840A Medalist sj5000 Hardware Manual page 73

Testing the Move, Stop, and Jog Functions
Agilent U1840A Medalist sj5000 Hardware Manual
To test the Move function, follow the instructions below:
Enter 200 mm in the Required Width field and click Move.
1
2
Wait until 200 mm is displayed in Current Width.
3
Using Vernier calipers, check that the width of the conveyor
is 200 mm ±0.5 mm at both ends.
Enter 100 mm into the Required Width field and click Move.
4
5
Wait until 100 mm is displayed in Current Width.
6
Using Vernier calipers, check that the width of the conveyor
is 100 mm ±0.5 mm at both ends.
7
Exit the AWA menu, wait 5 seconds, and re-enter the AWA
menu.
8
Enter 150 mm into the Required Width field. The conveyor
should first home and then move to 150 mm.
9
Using Vernier calipers, check that the width of the conveyor
is 150 mm ±0.5 mm at both ends.
To test the Stop function, do the following:
Enter 300 mm in the Required Width field and click Move.
1
Before the conveyor reaches this width, click Stop.
2
3
Using calipers, measure the distance between the two rails
and check that it corresponds to the value in Current Width.
To test the Jog function, do the following:
Select a step size and click Jog Out or Jog In to jog the
1
conveyor rails.
The value in the Current Width field should increase or
decrease correspondingly.
2
Using Vernier calipers, measure the distance between the
two rails and check that it corresponds to the value in
Current Width.
3
This test should be run for all three conveyor step sizes, for
both the Jog Out and Jog In buttons.
Auto Width Adjust Conveyor Setup
6
6-11