Troubleshooting The Pc And Monitor - Agilent Technologies U1840A Medalist sj5000 Hardware Manual

Troubleshooting the PC and Monitor

Agilent U1840A Medalist sj5000 Hardware Manual
If the PC is not working
• Check that the PC is plugged in and switched on.
• Check that MCB Q5 is on.
• If UPS is used, make sure that it is switched on.
• Determine if any hard disk is damaged using the Matrix
Storage Console utility. Click Start > All Programs > Intel Matrix
Storage > Matrix Storage Console to view a report on the hard
drives. If a hard disk has failed, contact Agilent Support to
get a new hard disk.
• To remove a failed hard disk, open the PC cover, remove the
power and SATA connectors, and pull out the hard disk.
• To install the replacement hard disk, insert it and then
connect the power and SATA connectors.
• Restart the PC and check automatic rebuilding. This can take
three hours.
If the monitor is not working
• Check that the monitor is connected and switched on.
• Check that MCB Q5 is on.
• Check that the cables are properly connected.
• If UPS is used, make sure that it is switched on.
11
Troubleshooting
11-17