Agilent Technologies U1840A Medalist sj5000 Hardware Manual page 30

2
Introduction to the Medalist sj5000
2-8
Table 2-1 Controls on the switch plate
Item Description
AWA buttons Allow you to manually adjust the distance between
the conveyor rails. The top white button narrows the
distance between the rails and the bottom black
button widens it. For more information, see
Width
PLC RESET button Resets the PLC.
MAINT. SWITCH Allows you operate the board clamps and stops in an
E-Stop condition.
Front Electrical Interface Module
The front electrical interface module is the electrical junction
where the conveyor sensors are terminated and interfaced with
cable 5186-6300. The cable is in turn fed through the base of the
machine to the control panel and terminated at XB1 on the
terminal rail. See the Electrical Drawing document for the pin
number reference.
Figure 2-4 Front electrical interface module
Adjust".
Agilent U1840A Medalist sj5000 Hardware Manual
"Manual