Agilent Technologies U1840A Medalist sj5000 Hardware Manual page 9

WA RNING
WA RNING
Environmental Conditions
C A U T I O N
Agilent U1840A Medalist sj5000 Hardware Manual
DO NOT REMOVE RACK PANELS OR INSTRUMENT COVERS. Operating
personnel must not remove any rack panels or instrument covers.
Component replacement and internal adjustments must be made only
by qualified service personnel. Products that appear damaged or
defective should be made inoperative and secured against unintended
operation until they can be repaired by a qualified service personnel.
The protection provided by the Agilent U1840A Medalist sj5000
system may be impaired if the system is used in a manner not
specified by Agilent.
The Agilent U1840A Medalist sj5000 Automated Optical Inspec-
tion System is designed for indoor use only.
general environmental requirements.
Table 1-1 Environment Requirements
Environment Conditions
Maximum Altitude
Temperature (Operation)
Maximum Relative Humidity
This product is designed for use in Installation Category II and
Pollution Degree 2, per IEC 61010-1 and 664 respectively. The
operating voltage should be in the range of 100-120 VAC/200-240
VAC, 50/60 Hz (8 A) with the Mains Supply Voltage fluctuations not
to exceed ±10% of the nominal voltage.
Safety and Regulatory Information
Table 1-1
Requirements
2000 meters
° °
5 C to 40 C
The test system is designed to operate
in the range from 5% to 80% relative
humidity (non-condensing) with 80%
for temperature up to 31°C, decreasing
linearly to 50% relative humidity at
40°C
1
shows
1-3