Agilent Technologies U1840A Medalist sj5000 Hardware Manual page 56

4
Starting Up the Medalist sj5000
4-6
• The board is then released:
• The clamps and stops are lowered.
• The board drops smoothly onto the conveyor and the
conveyor starts running.
• The board transfers to the Exit sensor.
• The sj5000 signals the inspection result to the downstream
machine via SMEMA (pins 3 and 4 closed = Good Board
Available, 3 and 5 closed = Bad Board Available)
• When the sj5000 gets a 'Machine Not Busy' signal from the
downstream machine, the conveyor is driven until the board
exits the machine and the cycle begins again.
Agilent U1840A Medalist sj5000 Hardware Manual